- Forums
- »
- Technics Keyboards, PR & PX Forum
- »
- PR50 assembly
|
Viewing 1 to 2 (2 Total) PR50 assembly |
|
|---|---|
coffeesnob
Total Posts: 1
Joined: August 30, 2018
|
We took this piano apart when the daughter moved out. She lost the screws that are used to assemble the speaker, legs and pedal. Anybody have an idea what size they are? Thanks
Tags:
Posted on August 30, 2018 at 12:11 PM
|
|
|
|
jd5live
United Kingdom Total Posts: 360
Joined: June 8, 2014
|
Re: PR50 assemblyHi and welcome to the site, The screws you are after are listed in the parts list but sadly they do give the measurements for the screws you need. As I was a dealer back in the early 1990's I have assembled quite a few PR50 and if I remember correctly the bolts are approx 4mm dia maybe M5 but I think they were M4. The 8 you require for the speaker pod and to attach the top are about 25mm long. you will need washers with all of them. the ones to attach the base unit are the same dia. but longer, about 60/70mm again needing washers with each. My recommendation is to take a side panel to a local enginee's merchant to get the correct size and thread you need 12 screws in total. Take care when screwing into the top unit proceed with caution as I am not sure if there are any electronics mounted directly above the screw holes you could check the depth of the mounting holes in the top unit by putting a wooden cocktail stick into the hole to check the clearance (done carefully you won't do any damage to anything inside the case)
Posted on August 30, 2018 at 9:53 PM
|